====== TACTILE SENSOR MODULE (KY-036) ======
{{:documentation:microcontroleurs:arduino:modules:tactile_sensors:ky036.jpg?direct|}}
{{:documentation:microcontroleurs:arduino:modules:tactile_sensors:ky036_2.png?direct|}}
\\
{{:documentation:microcontroleurs:arduino:modules:tactile_sensors:ky_036_metal_touch_sensor_module.png?direct&400|}}
\\
{{:documentation:microcontroleurs:arduino:modules:tactile_sensors:ky036_pinout.png?direct|}}
\\
{{:documentation:microcontroleurs:arduino:modules:tactile_sensors:ky036_drawing.png?direct|}}
===== ARDUINO WIRING =====
{{:documentation:microcontroleurs:arduino:modules:tactile_sensors:ky036_arduino_wiring.png?600|}}

===== CODE =====
==== EXAMPLE #1 ====
<code cpp>
// Arduino and KY-036 module

void setup ()
{
pinMode (13, OUTPUT); // built-in LED pin set to output
pinMode (8, INPUT); // module digital output connected to Arduino pin 8
Serial.begin(9600); // initialize serial
}

void loop ()
{
// display analog and digital values to serial
Serial.print("Analog pin: ");
Serial.print(analogRead(A0));

Serial.print(" | Digital pin: ");

if (digitalRead(8) == HIGH) {
Serial.println("High");
digitalWrite (13, HIGH); // if module value is higher than threshold,
// switch-On built-in LED
}
else {
Serial.println("Low");
digitalWrite (13, LOW);
}

delay(100); // wait 100 milliSeconds
}
</code>